Requiring a permit under section 10 of the Act. (1) Part 10 of Division B applies to existing buildings (iv) Group F, Divisions 2 and 3, medium hazard industrial occupancies and low hazard industrial occupancies. (iii) Group E, mercantile occupancies, or (i) Group C, residential occupancies other than buildings (c) used for major occupancies classified as, (b) having a building area not exceeding 600 m 2, and (a) of three or fewer storeys in building height, (1) Subject to Article 1.1.2.6 Part 9 of Division B applies to all buildings, Of buildings in the vicinity of sewage systems. (1) Subject to Article 1.1.2.6., Part 8 of Division B applies to the design, construction, operation and maintenance of all sewage systems and to the construction of Division B applies to demountable stages and demountable support structures. (j) a permanent solid nutrient storage facility with supporting walls exceeding 1 000 mm in exposed height. (i) an outdoor pool that has a water depth greater than 3.5 m at any point, and (h) a structure that supports a wind turbine generator having a rated output of more than 3 kW, of Division B that are not structurally supported by a building, (f) an exterior storage tank and its supporting structure that is not regulated by the Technical Standards and Safety Act, 2000, (d) a pedestrian bridge appurtenant to a building, (iii) private property to which the public is admitted, (c) a retaining wall exceeding 1 000 mm in exposed height adjacent to, and 1.3.1.2., Part 4 of Division B applies to, (iv) Group F, Divisions 2 and 3, medium hazard industrial occupancies and low hazard industrial occupancies, or (ii) Group D, business and personal services occupancies, In building height and used for major occupancies classified as, (b) exceeding 600 m 2 in building area or exceeding three storeys (ii) Group B, care, care and treatment or detention occupancies, or (a) used for major occupancies classified as, and 1.3.1.2., Parts 3, 5 and 6 of Division B apply to all buildings, (2) Subject to Article 1.1.2.6., Parts 7 and 12 of Division B apply to all buildings.ġ.1.2.2. (1) Part 1 of Division B applies to all buildings. (1) If a provision of this Code contains a reference to another provision of this Code but no Division is specified, both provisions are in the same Division of this Code.ġ.1.2.1. (1) Division C contains the administrative provisions of this Code. (1) Division B contains the acceptable solutions (1) Division A contains compliance and application provisions and the objectives and functional statements Materials, Appliances, Systems and Equipment Vanity Traps are P-Traps which feature an extra-long (15”) Wall Bend to accommodate deeper Vanity installations.Consolidation Period: From to the e-Laws currency date. This water in the trap creates a seal that prevents sewer gas from passing from the drain pipes back into the occupied space of a building or home. S-Traps are also used to prevent hazardous sewer gases from entering buildings, and are designed to drain into plumbing below the floor for installations where there is no access to plumbing directly behind the wall.īecause of their shape, J-Bends retain a small amount of water after the fixture’s use. If one with a cleanout plug is installed it can be cleaned without removing and installing a new trap. They are available with or without cleanout plugs. The Tailpiece on the Lavatory Drain fits into the P-Trap J-Bend, connecting to the Wall Bend, which then enters the wall. A P-Trap is comprised of a curved “trap” called a J-Bend and a drain pipe called a Wall Bend. P-Traps can be found at almost any fixture that drains water and are designed to prevent hazardous sewer gases from entering the building.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |